In this episode we will embark on a journey into the depths of colour management and go where no colour negative film-shooting photographer has gone before. Well, I bet they have but I can’t find anything else like it on the internet…
In Scanning Colour Negative Film 101 we learned how to scan a piece of colour negative film in Nikon Scan using the standard negative mode as well as how to get a full range gamma 1.0 positive scan that we can use to do our own positive inversion with. Continue reading to start exploring how to do this in three progressively more complex but powerful ways. Because we are dealing only with processing the inversion of the positive scan the techniques discussed here are equally applicable for positive scans obtained via any scanner or software, even so-called “DSLR” scans. For DSLR scans, however, there are some special considerations that we will touch on in the third installment.
So you want to scan negative film? Well, it’s not too hard to be happy if you don’t look too far. I spent my first several years just using the “negative” mode on Nikon Scan with my Nikon Coolscan 9000ED and I was very happy. Nikon Scan does a very good and artistically satisfying job, in my opinion. It is all well and good until you want some control over the process. Let’s say, you don’t like the clipping point where your brights get cut off. Let’s say you end up with a colour cast in the shadows or across the whole image. Let’s say the shadows are crushed. What can you do? Well, nothing, my friend. Nothing unless you take over.
I know there are a few guides out there for home processing, some of which were instrumental in helping me get over my fears. All of these other guides seemed to be a little incomplete and that lack of detail made me wait longer than I should have before taking the plunge. In reality, it’s EASY to do your film at home. Let me show you!